Vararam C5 VR Power Duct Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Vararam C5 VR Power Duct. Vararam C5 VR Power Duct User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
C5 VR Power Duct installation instructions.
First note -The VR power duct is designed to be used with many different air induction systems not just VR sys-
tems. We include extra hose length both front and rear for you to trim to allow for a custom t for your application.
Kit contents
1 VR power duct
3 pieces of red silicon hose
4 hose clamps
(Mass Air Not Included)
Please read completely through if at any point you have questions please call us at 713-899-6456 or drop our tech
an e-mail at [email protected]
Slip 4-inch hose over the front of the duct and tighten with supplied clamp. Fit this end to your vehicle 1st this will
allow you to set the height of the duct, custom trim if needed, otherwise use a second clamp and tighten to your air
box of choice.
Your stock MAF will insert directly into the rear of the VR duct (years 2001-2004), If you have an early car 1997-
2000 you will do the same, however, you will use duct part number VRD2. The MAF will insert rmly tighten
clamp completely
Using supplied 1 inch hose (3.5X1) slip this over the back of your MAF, its being used as a slip t. Using remaining
2X4 hose, lay this hose next to the mouth of the throttle body and the back of the MAF, mark and cut accordingly.
YOU MUST USE the 1inch slip t hose to match up the throttle body OD to the MAF OD . The tail of the MAF is
smaller than the mouth of your throttlebody, use of this slip hose evens out the OD’s
One nal and critical step!
Once completed with the installation re up your car and run the engine with the hood shut for 5min or so to reach
max temp, basically heat soak the engine compartment! Now go back and tighten the MAF to VR duct connection
with a socket wrench, this will create a precision t between the MAF and VR duct
Vue de la page 0
1

Résumé du contenu

Page 1

C5 VR Power Duct installation instructions. First note -The VR power duct is designed to be used with many different air induction systems not just VR

Commentaires sur ces manuels

Pas de commentaire