Vararam Tri-Power Manuel d'utilisateur télécharger pdf (Page 3)

Using your cutters remove aps as shown, they are connected by plastic push clips in 3 locations

SUV’s usually have the soft fabric ex Avalanche, Escalade, Denali etc… Simply reach in and pull on the fabric, pop these

loose, they are connected at the top in two locations and one location on the bottom. Wear gloves or pad the area so you don’t

hurt your hands here, lots of sharp corners. (You may also use cutters to cut these out)

Once step one is completed feel underneath the radiator core support as shown. You will nd a 10mm bolt on each side.

Loosen this about 1/8 - 1/4 of an inch. ( this will be used for slotted bracket placement for mounting the front scoops)

Remove VR kit from shipping box, the lter is already loaded and oiled, ready for use. We even pre crushed the hoses for you.

Tech note – there is a left and right duct, drivers side has perm nut hole on the right side as shown

1 2 3 4 5 6

Pas de commentaire

Vararam Tri-Power Manuel d'utilisateur Page 3